1、双组份打胶机设备应安装在干燥、无粉尘、无腐蚀性气体的坏境中（该要求与其他设备一致，当然如果条件达不到至少争取无腐蚀性气体，毕竟设备中有电线以及管路这些配件抗腐蚀性不高）。

1. The two-component glue machine equipment should be installed in a dry, dust-free, and corrosion-free environment (this requirement is consistent with other equipment, but if the conditions are not met, at least strive for corrosion-free gas, after all, there are wires and pipelines in the equipment, and these accessories have low corrosion resistance).

　　2、最好在室内坚硬地面上，地面应水平度要好。

2. It is best to place it on a hard indoor floor with good levelness.

　　3、双组份打胶机安装之前，应先检查是否有因运输、搬动造成的变形、损坏和紧固件松动情况，之前就曾经有客户在移动打胶机的过程中把设备的智能控制系统的一个零部件碰掉了而导致设备无法正常运行，我们的工作人员到现场后才排查出的原因。

3. Before installing the two-component glue machine, it is necessary to check for any deformation, damage, or loose fasteners caused by transportation or moving. Previously, a customer had accidentally knocked off a component of the intelligent control system of the equipment while moving the glue machine, causing it to malfunction. Our staff only found out the cause after arriving at the site.

　　4、首先我们可以根据地面平整度的实际情况来通过调整设备的可升降地脚螺栓来调整设备的水平度直到设备水平而稳固。然后按图接线并可靠接地，把气源接入机器所配带的气源接口，确保无漏气现象。

4. Firstly, we can adjust the levelness of the equipment by adjusting the adjustable anchor bolts based on the actual situation of ground flatness until the equipment is level and stable. Then connect the wires according to the diagram and ground them reliably, connect the air source to the air source interface provided by the machine, and ensure that there is no air leakage.

　　5、向油槽中加注液压油至指定位置。

5. Add hydraulic oil to the oil tank to the specified position.

　　6、接通电源并打开查看设备是否能够正常运行。

6. Turn on the power and check if the device is functioning properly.

本文由 双组份打胶机 为您精心提供，如想了解更多请点击我们的网站： http://www.jncsjx.com，我们将会以最大的热情为您解答!

This article is carefully provided by a two-component gluing machine. If you want to learn more, please click on our website: http://www.jncsjx.com We will answer you with the greatest enthusiasm!