Butyl rubber coater common problems of solutions, I hope to help you.

1.铝框上出现一边或两边都不沾胶的现象时

1. When one or both sides of the aluminum frame are free of glue

**我们应检查胶缸、胶头的温度是否正常，压力是否在我们设定的范围之内，检查两胶头的距离是否过大（此距离设定至铝条刚刚能从两个打胶头之间过去为较好）。

**We should check whether the temperature of the rubber cylinder and rubber head is normal, whether the pressure is within the range we set, and whether the distance between the two rubber heads is too large (it is better to set this distance until the aluminum bar can just pass between the two rubber heads).

如果上述情况都没有问题，可断定两个打胶头（或一个），由于丁基胶中有杂质而堵住了胶头出胶的眼，这就需要卸下打胶头，用煤油浸泡，然后将胶头内的胶全部清理干净后再装上即可。

If there is no problem in the above situations, it can be concluded that two rubber applicators (or one) have blocked the rubber outlet of the rubber applicator due to impurities in butyl rubber, so it is necessary to remove the rubber applicator, soak it in kerosene, clean all the rubber in the rubber applicator, and then install it.

2.该设备全部采用液压系统，油缸及液压系统全部采用高压油管连接，每个连接处都由组合垫密封，若发现漏油，及时更换组合垫。

2. The equipment adopts hydraulic system, and the oil cylinder and hydraulic system are connected by high-pressure oil pipe. Each connection is sealed by a combination gasket. If oil leakage is found, the combination gasket shall be replaced in time.

3.该设备的胶头加热和胶缸加热，由加热棒两个和加热盘一个提供，由温控表来设定和调整温度的高低，若发现温度升不高或升高后往下降，请检查加热棒或加热盘是否损坏，并检查温控表是否正常。

3. The rubber head heating and rubber cylinder heating of the equipment are provided by two heating rods and one heating plate. The temperature is set and adjusted by the temperature control meter. If the temperature does not rise or drops after rising, please check whether the heating rod or heating plate is damaged and whether the temperature control meter is normal.

以上就是为大家介绍的有关丁基胶涂布机的详细的介绍,希望对您有所帮助.

The above is a detailed introduction of butyl rubber coating machine, and we hope it will be helpful to you. If you have any questions, please contact us.