1.由于双组份密封胶的固化需要一定时间，因此，已涂了双组份密封胶的玻璃应水平轻轻搬动。
1. Since the curing of the two-component sealant takes a certain time, the glass coated with the two-component sealant should be moved gently and horizontally.
2.A组、B组份胶应保持清洁，严防异物进入胶中。
Group 2.A and B components should be kept clean and prevent foreign substances from entering the glue.
3.在连续工作过程中，胶枪每次停止工作时间一般不得超过20分钟，否则，应用A组份胶冲出全部混合胶，直单一的A组份胶从枪口排出为止。
3. in the continuous working process, the glue gun will not stop working more than 20 minutes each time. Otherwise, all the mixed glue is washed out with A component glue until the single A component is discharged from the muzzle.
4.高压胶管不得强行挤压、弯曲，防止影响系统正常工作。

4. high pressure hose should not be forced to bend or bend to prevent the system from functioning normally.
5.混胶器应经常保持畅通，以保证良好的出胶效果。如遇堵塞情况，可用丙酮浸泡后清洗。建议每5组清洗一次。
5. rubber mixer should be kept smooth to ensure good glue production. In case of blockage, acetone can be soaked and cleaned. It is suggested that every 5 groups be cleaned once.
6.当胶枪长时间不用时，应拆下枪体使用溶剂将胶枪和混胶器内的残留胶体清洗干净。
6. when the rubber gun is not used for a long time, the gun body should be removed and the residual colloid in the rubber gun and the rubber mixer should be cleaned with solvents.
7.不同双组份胶生产厂家所生产的胶内含杂质数量不同，根据实际情况清晰B组分的过滤网及单向止回阀，建议每两组清洗一次。
7. the number of impurities in the rubber produced by the different double component rubber manufacturers is different. According to the actual situation, the filter net and the one-way check valve of the B component are clear. It is suggested that every two groups be cleaned once.
8.任何因胶体固化所造成的胶枪、管路或整机的故障，一律不在保修范围之内。
8. any failure of glue gun, pipe or whole machine caused by gel solidification is not within the scope of warranty.
9.定期给各泵的加油口加油，应保证油雾器内不断油。
9. regularly refueling the pumps, ensure that the oil mist is constantly oil.
以上就是今天的介绍,如果您想了解我公司产品的更多信息,欢迎您电话咨询,我们定会为您提供详细的产品信息。
Above is today's introduction, if you want to know more about our products, welcome to telephone consultation, we will provide you with detailed product information.