中空玻璃设备使用双组份打胶机的效果

时间:2018-01-25 来源:http://www.jncsjx.com/ 发布人:昌盛机械

  中空玻璃设备的保养总体方法不难,关键是要做好对设备滑轮的保养润滑,保证工作时候的电压稳定,预防电机出现烧毁的情况,确保设备能够正常运行就可以了。
  The overall maintenance method of the insulating glass equipment is not difficult. The key is to do well the maintenance lubrication of the equipment pulley, ensure the voltage stability at work time, prevent the motor from burning down, and ensure that the device can run normally.
  万一设备在工作期间发生了重大的故障,那么就需要聘请的维修人员前来处理。非人员切莫擅自拆机维修。
  In case of a major failure during the operation of the equipment, the professional maintenance personnel need to be hired to deal with it. Non professionals do not disassemble or repair.
  双组份打胶机要使得中空玻璃设备使用效果理想,玻璃清洗彻底干净,大程度的延长其使用寿命,就必须要注意其基本的保养常识。在设备使用过程中注意对其进行正确的保养。如何保养,如此表示。此外需要注意的一点是,当故障发生需要检修的时候,必须要先把总电源给切断了。除外,还需要注意的事项包括如下:

双组份打胶机
  The two component glue machine should make sure that the hollow glass equipment is ideal, the cleaning of glass is clean and the service life is extended to the greatest extent. We must pay attention to its basic maintenance knowledge. Pay attention to the correct maintenance of the equipment during the use of the equipment. How to maintain, the expert said so. In addition, one point to be noted is that when the failure needs to be overhauled, the total power supply must be cut off first. Besides, the following items should be noted as follows:
  设备内的水箱要保证系统水循环的正常,每周要对水箱进行一次彻底的清洗,要对喷水嘴进行常规性的检查,一旦发现有堵塞就要马上进行疏通清理。此外还有风路的维护,设备风机的运行情况要保持良好稳定。
  The water tank in the equipment should ensure the normal water circulation of the system. Once a week, the tank must be thoroughly cleaned. The nozzle should be checked routinely. Once there is a blockage, it is necessary to dredge and clean up immediately. In addition to the maintenance of the wind road, the operation of the equipment fan should be kept good and stable.
  对传送辊的维护。中空玻璃设备的关键零件传送辊必须要注意定期进行润滑处理,在设备运转之前要先检查器润滑情况,看油位线标是否正常,油位必须要保持在滑标的中心线以上才可以。
  Maintenance of the transmission roll. The key parts of insulating glass equipment must be careful to lubricate regularly. Before the operation of the equipment, check the lubricants first, see whether the oil level mark is normal, and the oil level must be kept above the centerline of the slide mark.
  本文由双组份打胶机为您提供,我们的网站是:http://www.jncsjx.com我们将以全心全意的热情为您提供更的服务,欢迎您的访问!
  This article is provided by two component glue machine. Our website is: http://www.jncsjx.com, we will provide you with better service with wholehearted enthusiasm, welcome your visit.

联系我们Contact us

  • 咨询热线:0531-85717458 13705446998
  • 公司地址: 山东省德州市齐河安头乡企巢工业园
  • 扫码联系我们:

截屏,微信识别二维码

微信号:13705446998

//