要使得中空玻璃设备使用效果理想，玻璃清洗彻底干净，大程度的延长其使用寿命，就必须要注意其基本的保养常识。在设备使用过程中注意对其进行正确的保养。

In order to make the use of insulating glass equipment ideal, clean the glass thoroughly and extend its service life to a large extent, it is necessary to pay attention to its basic maintenance knowledge. Pay attention to correct maintenance of the equipment during use.

中空玻璃设备的保养总体方法不难，关键是要做好对设备滑轮的保养润滑，保证工作时候的电压稳定，预防电机出现烧毁的情况，确保设备能够正常运行就可以了。万一设备在工作期间发生了重大的故障，那么就需要聘请的维修人员前来处理。非人员切莫擅自拆机维修。此外需要注意的一点是，当故障发生需要检修的时候，必须要先把总电源给切断了。除外，还需要注意的事项包括如下：

The overall maintenance method of insulating glass equipment is not difficult. The key is to do a good job in the maintenance and lubrication of the equipment pulley, ensure the voltage stability during operation, prevent the motor from burning, and ensure the normal operation of the equipment. In case of major failure of the equipment during operation, it is necessary to hire professional maintenance personnel to deal with it. Non-professional personnel should not dismantle the machine for maintenance without authorization. In addition, it should be noted that when a fault occurs and needs to be repaired, the main power supply must be cut off first. In addition, matters needing attention include the following:

其一，对传送辊的维护。中空玻璃设备的关键零件传送辊必须要注意定期进行润滑处理，在设备运转之前要先检查器润滑情况，看油位线标是否正常，油位必须要保持在滑标的中心线以上才可以。

First, the maintenance of the transfer roller. The transmission roller, the key part of the insulating glass equipment, must be lubricated regularly. Before the equipment runs, check the lubrication of the device to see if the oil level mark is normal. The oil level must be kept above the center line of the sliding mark.

其二，设备系统的水路维护。设备内的水箱要保证系统水循环的正常，每周要对水箱进行一次彻底的清洗，要对喷水嘴进行常规性的检查，一旦发现有堵塞就要马上进行疏通清理。此外还有风路的维护，设备风机的运行情况要保持良好稳定。

Second, water maintenance of equipment system. The water tank in the equipment shall ensure the normal water circulation of the system. The water tank shall be thoroughly cleaned once a week, and the spray nozzle shall be regularly inspected. Once any blockage is found, it shall be cleared immediately. In addition, there is also the maintenance of the air path, and the operation of the equipment fan should be kept in good and stable condition.